Category: Edifice

How to set time on Edifice EQS-500

1. In the Timekeeping Mode, keep A depressed (for about five seconds) as the 2 Second Hand moves to the city code of the currently selected Home City. At this time, the 6 Right Dial Hand will indicate the Home City’s current daylight saving time setting (STD or DST). 2.…

Read More

How to set time on Edifice EQW-M1000

To change the current time setting manually 1. In the Timekeeping Mode, keep A depressed (for about five seconds) as the x Second Hand goes through the following sequence. Moves to the last signal reception result (Y or N), then to READY (or R for some models), and then to…

Read More

How to set time on Edifice ERA-100

1. In the Timekeeping Mode, hold down A for about two seconds until “SET” appears on the lower display. This is the setting mode. Note that keeping A depressed too long (for about five seconds) will cause a different type of setting mode to be entered. 2. Use D and…

Read More

How to set time on Edifice EQW-M1100

To change the current time setting manually 1. Use A as shown under “Setting Modes” to enter the “Manual Setting” mode. The 2 Second Hand will move to 12 o’clock. This is the time setting mode. In the following steps, each press of C cycles between settings as shown below.…

Read More

How to set time on Edifice EFA-118

1. In the Timekeeping Mode, hold down A until the seconds start to flash, which indicates the setting screen. 2. Press C to move the flashing in the sequence shown below to select the other settings. 3. When the setting you want to change is flashing, use B and D…

Read More