How to set time on Edifice EQW-A1000

Posted

in

,

The Ultimate Guide to All EDIFICEs โ€” composed by Experts

How to set time on Edifice EQW-A1000

Before using this guide, we recommend:

All settings are clearly explained and understandable.

1. In the Timekeeping Mode, unlock the crown and then pull it out.

  • This will cause the x Second Hand to move to the city code of the currently selected Home City.
  • At this time, the mode pointer will point to the current daylight saving time setting (STD, STD-AT, DST or DST-AT).
  • If you do not perform any operation with the crown for about three minutes after pulling it out, crown operations will become disabled and the hand will not move if you rotate the crown. If this happens, push the crown back in and then pull it out again.

How to set time on Edifice EQW-A1000

2. Change the Home City and daylight saving time (DST) settings, if you want.

  • For details about these settings, see steps 3 and 4 under โ€œTo confi gure Home City settingsโ€.

3. Hold down B for about two seconds. This will enter the time setting mode.

  • The Second Hand will move to A (AM) or P (PM).
  • In the following steps, each press of B cycles between settings as shown below.

How to set time on Edifice EQW-A1000

4. Rotate the crown to adjust the time (hour and minute) setting.

  • Rotating the crown two full consecutive turns away from you will cause the Minute Hand to start moving clockwise. Rotating the crown another two full consecutive turns away from you will cause the c Minute Hand to start moving at high speed. To stop hand movement, press any button or rotate the crown one full turn towards you.

5. Press B to switch to the hour setting mode.

  • The Hour Hand will move slightly left and right to indicate the z Hour Hand setting mode.
  • If you want to change the hour setting without changing the minute setting, skip step 4 above.

6. Rotate the crown to adjust the hour setting only.

  • Rotating the crown two full consecutive turns away from you will cause the
  • Hour Hand to start moving clockwise.
  • When adjusting the setting, check to make sure that the x Second Hand correctly indicates A (AM) or P (PM).

Recent News about Casio Edifice EQW-A1000 Seriesย 

All Edifice EQW-A1000 News โ†’


by

Comments

2 responses to “How to set time on Edifice EQW-A1000”

  1. Jebat Avatar
    Jebat

    Hi,
    I can’t setting my EQS-A1000 such as Date, Time, Day.
    Any advice from you or any video that you can share.

  2. jebat Avatar
    jebat

    Soory my bad it is EQS-A1000

Leave a Reply

Your email address will not be published. Required fields are marked *