How to set alarm on Casio DBC-32

1. In the Alarm Mode, use [+] and [÷] to scroll through the alarm screens until the one whose time you want to set is displayed.

• You can configure alarm 1 as a snooze alarm or a one-time alarm. Alarms 2 through 5 can be used as one-time alarms only.
• The snooze alarm repeats every five minutes.

2. After you select an alarm, hold down A until the left hour setting of the alarm time starts to flash, which indicates the setting screen.

• This operation automatically turns on the alarm.

3. Use the keypad to input the alarm time and date.

• The flashing automatically advances to the right each time you input a number. You can also use B and C to move the flashing between input digits.
• To set an alarm that does not use a month and/or day setting, input 00 for each
• If you are using 12-hour timekeeping, press [=PM] while the hour or minute setting is flashing to toggle between AM and PM.
• When setting the alarm time using the 12-hour format, take care to set the time correctly as am (A indicator) or pm (P indicator).

4. Press A to exit the setting screen.

Alarm Operation

The alarm tone sounds at the preset time for 10 seconds, regardless of the mode the watch is in. In the case of the snooze alarm, the alarm tone operation is performed a total of seven times, every five minutes, until you turn the alarm off or change it to a one-time alarm.

• Pressing any button or key stops the alarm tone operation.
• Performing any one of the following operations during a 5-minute interval between snooze alarms cancels the current snooze alarm operation.

To test the alarm

In the Alarm Mode, hold down C to sound the alarm.

• Pressing C also toggles the currently display alarm or the Hourly Time Signal on and off.

To turn alarms 2 through 5 and the Hourly Time Signal on and off

1. In the Alarm Mode, use [+] and [÷] to select a one time alarm (alarms 2 through 5) or the Hourly Time Signal.
2. Press C to toggle it on and off.

• The current on/off status of alarms 2 through 5 is shown by indicators along the bottom of the displays (al-2 through al-5). The SIG indicator shows the on (SIG displayed)/off (SIG not displayed) status of the Hourly Time Signal.
• The alarm on indicators and Hourly Time Signal on indicator are displayed in all modes.
• While an alarm is sounding, the applicable alarm on indicator flashes on the display.

To select the operation of alarm 1

1. In the Alarm Mode, use [+] and [÷] to select alarm 1.
2. Press C to cycle through the available settings in the sequence shown below.

• The SNZ indicator and alarm 1 on indicator (al-1) are displayed in all modes.
• The SNZ indicator flashes during the 5-minute intervals between alarms.
• The alarm indicator (al-1 and/or SNZ) flashes while the alarm is sounding.